Design and Production of High Quality R/C planes, since 2004
The wait is over! Shipment is on the water and pre-orders are available!

Blog – Masonry with left sidebar

  • 260RR-2

    How to Remove and Re-install the Thrust Motor Shaft

    Step by step instructions on how to remove and replace a motor shaft.

    12
  • 260RR-2

    How to Fix Landing Gear Mount after a Hard Landing

    Repair guide on how to fix your Landing Gear Mount after a hard landing!

    10
  • 260RR-2

    How To Reinforce FiberFusion Motor Mount (older planes)

    This tutorial applies to the older discontinued planes only. The stock motor mount is plenty strong. However, in instances where prop…

    10
  • 260RR-2

    How To Replace A Damaged Motor Mount

    This type of damage is not as bad as it seems and its quite repairable. These things happens for a number of...

    10
  • 260RR-2

    How To Rig Up Servo Solder On Servo Extension Cables

    Overview Here’s a simple way to rig up the solder-on lightweight servo extension cables for a neat installation and to get...

    13
  • 260RR-2

    How balancing cables are connected to Lipo Packs

    How balancing cables are connected to Lipo Packs   Due to the non-standardization of current lipo manufacturers, there is no universal...

    12
  • 260RR-2

    Tips for Handling and Caring of Lithium Polymer Packs

    High Performance 3D/Freestyle flying requires four critical considerations for battery packs which are; consistent power throughout the entire duration of the...

    10
  • 260RR-2

    How To Assemble PA Z-Bend Pushrods

    Prior to strating on the assembly you need the following:- A pair of scissors disposable lighter Good quality thin CA e.g....

    11

0 Comments

Leave a reply

error: