-
How to Modify the Thrust 10 to Thrust 40 Motor for Back Mounting
By aerofundan on 07/28/20161Overview Thrust motors can be modified for back mount operations if needed. Items required are as follows:- Stepped Wheel...
-
How to Remove and Re-install the Thrust Motor Shaft
By aerofundan on 07/28/2016Here are the step by step pictures on how to remove and replace the motor shaft. Tools required in...
-
How to Fix Landing Gear Mount after a Hard Landing
By aerofundan on 07/28/2016You will need the following: 30 minute epoxy Fiberglass cloth Brush Denatured alcohol Clear polythene bag (plastic bag) Masking...
-
How To Reinforce FiberFusion Motor Mount
By aerofundan on 07/28/2016Introduction The stock motor mount is plenty strong. However, in instances where prop strikes are becoming frequent or when...
-
How To Replace A Damaged Motor Mount
By aerofundan on 07/28/2016This type of damage is not as bad as it seems and its quite repairable. These things happens for a...
-
How To Rig Up Servo Solder On Servo Extension Cables
By aerofundan on 07/28/2016Overview Here’s a simple way to rig up the solder-on lightweight servo extension cables for a neat installation and...
-
How balancing cables are connected to Lipo Packs
By aerofundan on 07/28/2016How balancing cables are connected to Lipo Packs Due to the non-standardization of current lipo manufacturers, there is...
-
Tips for Handling and Caring of Lithium Polymer Packs
By aerofundan on 07/28/2016High Performance 3D/Freestyle flying requires four critical considerations for battery packs which are; consistent power throughout the entire duration...
-
How To Assemble PA Z-Bend Pushrods
By aerofundan on 07/28/2016Prior to strating on the assembly you need the following:- A pair of scissors disposable lighter Good quality thin...
-
-