Blog – Standard with right sidebar

Overview Here’s a simple way to rig up the solder-on lightweight servo extension cables for a neat installation and to get rid of excess weight. Items Required. 18W Low Power Soldering Iron Solder Flux paste 2mm and 6mm heat shrink insulation Cutting pliers Sharp Blade Electronic Work Centre Vise Needle nose pliers Lightweight servo cable Male servo connectors

How balancing cables are connected to Lipo Packs   Due to the non-standardization of current lipo manufacturers, there is no universal form factor for the balancing plugs and this becomes quite a nightmare for most EP enthusiasts owning a several brands of battery packs.   Although the JST-HXT form factor appears to be the most common “standard” adopted, there are

High Performance 3D/Freestyle flying requires four critical considerations for battery packs which are; consistent power throughout the entire duration of the sequence, light enough to be within the prescribed AWT of the model to retain design flight characteristics, properly sized to accommodate the demands of the drive system and a long trouble free service life.   Lithium Polymer packs (Lipo)

Prior to strating on the assembly you need the following:- A pair of scissors disposable lighter Good quality thin CA e.g. Zap Thin CA (Pink Bottle) Sand paper Step 1. Lightly sand the end section of the CF pushrod along the area where the metal Z-bend would be glued to. (This provides a much stronger glue bond) Step 2. Take