Design and Production of High Quality R/C planes, since 2004
The wait is over! Shipment is on the water and pre-orders are available!

Blog

  • AMR 60 iPAs set up - 1

    How to Modify the Thrust 10 to Thrust 40 Motor for Back Mounting

    These motors can be modified for back mount operations if needed. This article explains how to.

  • AMR 60 iPAs set up - 1

    How to Remove and Re-install the Thrust Motor Shaft

    Step by step instructions on how to remove and replace a motor shaft.

  • AMR 60 iPAs set up - 1

    How to Fix Landing Gear Mount after a Hard Landing

    Repair guide on how to fix your Landing Gear Mount after a hard landing!

  • AMR 60 iPAs set up - 1

    How To Reinforce FiberFusion Motor Mount (older planes)

    This tutorial applies to the older discontinued planes only. The stock motor mount is plenty strong. However, in instances where prop strikes are becoming frequent or when flying on…

  • AMR 60 iPAs set up - 1

    How To Replace A Damaged Motor Mount

    This type of damage is not as bad as it seems and its quite repairable. These things happens for a number of reasons such as: 1.The use of excessive force...

  • AMR 60 iPAs set up - 1

    How To Rig Up Servo Solder On Servo Extension Cables

    Overview Here’s a simple way to rig up the solder-on lightweight servo extension cables for a neat installation and to get rid of excess weight. Items Required. 18W Low...

  • AMR 60 iPAs set up - 1

    How balancing cables are connected to Lipo Packs

    How balancing cables are connected to Lipo Packs   Due to the non-standardization of current lipo manufacturers, there is no universal form factor for the balancing plugs and this...

  • AMR 60 iPAs set up - 1

    Tips for Handling and Caring of Lithium Polymer Packs

    High Performance 3D/Freestyle flying requires four critical considerations for battery packs which are; consistent power throughout the entire duration of the sequence, light enough to be within the prescribed...

0 Comments

Leave a reply

error: