Design and Production of High Quality R/C planes, since 2004
High volume of orders and thorough quality inspection prior to shipping both impact order processing times. Expect delays. Thank you for your support!

Blog – Mini with no sidebars

  • export_order-2021_04_12-08_50_45-32361739.txt

    How To Replace A Damaged Motor Mount

    By aerofundan on 07/28/2016
    0

    This type of damage is not as bad as it seems and its quite repairable. These things happens for a number of reasons such as: 1.The use of excessive force when inserting the motor mount into the fuselage during the build. 2. Accidental knocks during transportation 3. Extremely high-G maneouver over-stressing the airframe (due very violent maneouver at excessive speeds). I

  • export_order-2021_04_12-08_50_45-32361739.txt

    How To Rig Up Servo Solder On Servo Extension Cables

    By aerofundan on 07/28/2016
    2

    Overview Here’s a simple way to rig up the solder-on lightweight servo extension cables for a neat installation and to get rid of excess weight. Items Required. 18W Low Power Soldering Iron Solder Flux paste 2mm and 6mm heat shrink insulation Cutting pliers Sharp Blade Electronic Work Centre Vise Needle nose pliers Lightweight servo cable Male servo connectors

  • export_order-2021_04_12-08_50_45-32361739.txt

    How balancing cables are connected to Lipo Packs

    By aerofundan on 07/28/2016
    1

    How balancing cables are connected to Lipo Packs   Due to the non-standardization of current lipo manufacturers, there is no universal form factor for the balancing plugs and this becomes quite a nightmare for most EP enthusiasts owning a several brands of battery packs.   Although the JST-HXT form factor appears to be the most common “standard” adopted, there are

  • export_order-2021_04_12-08_50_45-32361739.txt

    Tips for Handling and Caring of Lithium Polymer Packs

    By aerofundan on 07/28/2016
    0

    High Performance 3D/Freestyle flying requires four critical considerations for battery packs which are; consistent power throughout the entire duration of the sequence, light enough to be within the prescribed AWT of the model to retain design flight characteristics, properly sized to accommodate the demands of the drive system and a long trouble free service life.   Lithium Polymer packs (Lipo)

  • export_order-2021_04_12-08_50_45-32361739.txt

    How To Assemble PA Z-Bend Pushrods

    By aerofundan on 07/28/2016
    1

    Prior to strating on the assembly you need the following:- A pair of scissors disposable lighter Good quality thin CA e.g. Zap Thin CA (Pink Bottle) Sand paper Step 1. Lightly sand the end section of the CF pushrod along the area where the metal Z-bend would be glued to. (This provides a much stronger glue bond) Step 2. Take

error: