Specification:
Continuous current: 65A
Burst Current (<10s): 80A
SBEC Output (Peak Loads 10sec): 5.5V/4A (max)
Li-ion/ LiPo: 2-6 Cells
NiMh/NiCd: 5-18 Cells
Note: The PA Quantum 65A SBEC has a4A switching power regulator chip which supports the high torque micro servos in the most demanding load-conditions imposed during aggressive 3D aerobatics, providing bulletproof reliability. In this form of flying the servos actuating oversized control surfaces and may stall momentarily under extreme aerodynamic loads. These loads may cause most low and medium power BECs to overheat and shutdown resulting in catastrophic loss of control.
The PA Quantum ESC’s high power SBEC has been specifically designed for extreme aerobatics and therefore has the capability to support the higher momentary peak loads to eliminate the possibility of unwanted shutdowns. This high power SBEC is also capable of supporting continuous simultaneous multiple servo operations typically found in CCPM equipped hardcore 3D E-helicopters.
The higher and stable SBEC voltage also reduces the possibility of receiver brownouts that occasionally occur on some 2.4GHz receivers in instances where conventional linear BECs are subjected to high servo loads causing the BEC voltage to drop below the voltage threshold required by the 2.4GHz receiver.
Features:
-
Extremely low internal resistance
-
Super smooth and accurate throttle linearity
-
Safety thermal over-load protection
-
Auto throttle shut down in signal lose situation
-
Supports high RPM motors
-
Power arming protection (prevents the motor from accidentally running when switched ON)
-
NEW Advanced programming software
-
Built in programmer card interface *
-
PC Link programming interface *
-
Upgradeable firmware interface *
-
Automatic Lipo cell count detection (also automatically sets the LVC point)
-
ESC over voltage protection (automatically disables when battery voltage exceeds 26V when initially connected).
-
A Green LED indicated that the ESC is powered ON or plugged to the PC (programming and upgrades)
* Programmer card, software and USB linker are optional upgrades. |
Instruction Manual
